Stainless Jet Pump Wear Ring for Sea-Doo Sportster 650 1995

Stainless Jet Pump Wear Ring for Sea-Doo

This stainless steel jet pump wear ring is a replacement component that restores the close clearance between the impeller and pump housing on your personal watercraft jet drive.

Overview

This jet pump wear ring is a stainless steel replacement component designed to maintain the critical clearance between the impeller and the pump housing. A worn or scored wear ring allows water to bypass the impeller, robbing your craft of thrust and acceleration. Installing a fresh stainless wear ring on a Sea-Doo Sportster 650 jet pump helps restore lost performance.

Built For Performance

• Stainless steel construction resists corrosion in fresh and salt water
• Maintains proper impeller-to-housing clearance for efficient water flow
• Designed to reduce cavitation and restore lost thrust
• Direct replacement for the worn ring in the jet pump assembly
• Machined for a precise fit within the pump housing

Fits These Machines

• for Sea-Doo Sportster 650 (1995)

On-The-Job Use

• Jet pump rebuilds and routine wear ring replacement
• Restoring acceleration and top speed on aging jet drives
• Scheduled maintenance on personal watercraft and jet boats
• Repairing cavitation and thrust loss caused by a scored ring

Specs At A Glance

Good To Know

Q: Why does the wear ring need replacing? A: Over time the ring surface gets scored and worn, increasing clearance so water slips past the impeller instead of being pushed out. A worn ring shows up as slower hole shots and reduced top speed.

Q: Is this an original manufacturer part? A: This is an aftermarket stainless wear ring made to fit the listed Sea-Doo jet pump application. It is not an original brand component.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.