Stainless Jet Pump Wear Ring for Sea-Doo XP 650 1993-1994

Stainless Jet Pump Wear Ring for Sea-Doo XP 650

This stainless jet pump wear ring is a replacement component for the Sea-Doo XP 650 that restores the close clearance between the impeller and pump housing to keep water pressure strong.

Overview

This stainless jet pump wear ring is made to fit the Sea-Doo XP 650 and serves as the sacrificial surface inside the jet pump housing. As the impeller spins against it, the wear ring absorbs abrasion from sand and debris so the housing itself stays protected. It suits riders rebuilding a pump or chasing lost top speed on an older personal watercraft.

Built For Performance

• Stainless steel construction resists corrosion in fresh and salt water
• Restores tight impeller-to-housing clearance for stronger thrust
• Acts as a sacrificial wear surface that protects the pump housing
• Direct replacement footprint for the Sea-Doo XP 650 jet pump
• Handles grit and sand that pass through shallow-water intakes

Fits These Machines

• for Sea-Doo XP 650

On-The-Job Use

• Pump rebuilds on 1993 to 1994 XP 650 models
• Restoring top speed and acceleration after wear
• Routine jet drive maintenance
• Shallow-water riding where sand and debris pass through the pump

Specs At A Glance

Good To Know

Q: Why does a wear ring need to be replaced? A: The ring takes the friction from the spinning impeller, and once its clearance opens up the pump loses pressure and thrust. Swapping it is far cheaper than replacing the pump housing.

Q: Will this fit my XP 650 with the original pump? A: It is intended for the Sea-Doo XP 650 jet pump, but pump and serial number differences exist. Confirm your pump housing part number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.