Stainless Jet Pump Wear Ring for Sea-Doo XPI 650 1994

Stainless Jet Pump Wear Ring for Sea-Doo

This stainless steel jet pump wear ring is a replacement component that restores the tight clearance between the impeller and pump housing on 1994 Sea-Doo XPI 650 watercraft, helping maintain proper thrust and pump efficiency.

Overview

This jet pump wear ring is a durable stainless steel replacement for the worn ring in your Sea-Doo XPI 650 jet pump assembly. The jet pump wear ring controls the gap around the impeller so water pressure stays consistent, which protects acceleration and top speed on the water. It is built for riders and mechanics servicing 1994 Sea-Doo XPI 650 personal watercraft.

Built For Performance

• Stainless steel construction resists corrosion in fresh and salt water
• Machined ring shape holds a consistent impeller clearance
• Restores lost pump pressure caused by a worn or scored ring
• Direct replacement for the stock wear ring location in the pump housing
• Withstands the abrasion of sand and debris passing through the pump

Fits These Machines

• for Sea-Doo XPI 650, 1994

On-The-Job Use

• Routine jet pump rebuilds and impeller replacement
• Restoring performance after cavitation or loss of thrust
• Seasonal maintenance on older Sea-Doo watercraft
• Freshwater and saltwater riding environments

Specs At A Glance

Good To Know

Q: What does a wear ring do in a jet pump? A: It maintains a small, even gap around the impeller so the pump can build pressure and push water efficiently. A worn ring opens that gap and causes cavitation, which shows up as sluggish acceleration.

Q: When should a wear ring be replaced? A: Replace it whenever the ring is scored, grooved, or the impeller clearance exceeds specification, or during any pump rebuild. Inspecting it while the pump is apart is the easiest way to catch wear early.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.