Standard Piston Kit for Honda Recon 250 1997-2001
Standard Piston Kit for Honda Recon 250 1997-2001
Couldn't load pickup availability
Standard Piston Kit for Honda Recon 250
This standard piston kit is a direct-fit rebuild component for the Honda Recon 250, restoring factory bore dimensions for top-end engine service. It includes the piston, rings, pin, and clips needed to bring a worn top end back to spec on 1997-2001 models.
Overview
This standard piston kit for the Honda Recon 250 is built to restore factory bore size on 1997 through 2001 models during top-end rebuilds. The kit supplies the piston, rings, wrist pin, and circlips so a worn or scored top end can be brought back to original specification. It suits riders and mechanics handling routine engine refresh work on the Recon 250.
Built For Performance
- Standard bore sizing matches the original Honda Recon 250 cylinder dimensions
- Includes piston, ring set, wrist pin, and circlips for a complete top-end refresh
- Ring set designed for consistent sealing and compression recovery
- Wrist pin and clips sized to the original connecting rod assembly
- Constructed from cast aluminum alloy for dependable wear resistance
Fits These Machines
- for Honda Recon 250 (1997-2001)
On-The-Job Use
- Top-end rebuilds after loss of compression or oil consumption
- Cylinder reconditioning when the bore remains within standard spec
- Routine engine refresh on higher-hour Recon 250 machines
- Trail and utility riding where reliable compression matters
Specs At A Glance
| Part Type | Standard Piston Kit |
| Bore Size | Standard |
| Fitment | Honda Recon 250 |
| Model Years | 1997-2001 |
| Kit Contents | Piston, Rings, Wrist Pin, Circlips |
Good To Know
Q: When should I choose standard over an oversize piston? A: Standard sizing is right when the cylinder bore still measures within factory spec and only needs a light hone. If the bore is worn or scored, an oversize piston matched to the machined cylinder is the better path.
Q: Are ring end gaps set out of the box? A: Ring end gaps should always be checked against the cylinder before assembly, since final clearance depends on bore condition. Follow the service manual spec during installation.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
