Starter Relay Solenoid for Ski-Doo Grand Touring 600 E-Tec LE 2013-2018

Starter Relay/Solenoid for Ski-Doo Grand Touring 600 E-Tec LE

This starter relay and solenoid is a replacement electrical component that routes battery current to the starter motor on Ski-Doo Grand Touring 600 E-Tec LE snowmobiles, letting the engine crank reliably in cold conditions.

Overview

This starter relay solenoid serves as the high-current switch between the battery and the starter motor on Ski-Doo Grand Touring 600 E-Tec LE machines. It handles the amperage draw of the starter so the ignition circuit and handlebar switch stay protected.

Built For Performance

• Heavy-duty contact points rated for repeated high-current starting cycles
• Sealed housing resists snow, ice, and moisture intrusion
• Coil wound for consistent pull-in at low temperatures
• Corrosion-resistant terminals for dependable connection
• Direct-fit mounting pattern for the factory relay location

Fits These Machines

• for Ski-Doo Grand Touring 600 E-Tec LE 2013
• for Ski-Doo Grand Touring 600 E-Tec LE 2014
• for Ski-Doo Grand Touring 600 E-Tec LE 2015
• for Ski-Doo Grand Touring 600 E-Tec LE 2016
• for Ski-Doo Grand Touring 600 E-Tec LE 2017
• for Ski-Doo Grand Touring 600 E-Tec LE 2018

On-The-Job Use

• Trail riding in sub-freezing temperatures
• Repeated cold starts at trailheads and staging areas
• Touring with frequent engine shutdown and restart
• Seasonal maintenance and electrical troubleshooting

Specs At A Glance

Good To Know

Q: How do I check if the relay has failed? A: A failing relay often causes a single click or no response when the start button is pressed, even with a fully charged battery. Testing for voltage at the starter-side terminal while cranking helps confirm the diagnosis.

Q: Is this a direct replacement? A: This relay solenoid is built to fit the listed Ski-Doo Grand Touring 600 E-Tec LE model years directly. Confirm the connector style and mounting position match your machine before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.