Starter Relay Solenoid for Ski-Doo Renegade 850 E-Tec Adrenaline 2017-2026

Starter Relay/Solenoid for Ski-Doo Renegade 850 E-Tec Adrenaline

This starter relay and solenoid replaces the factory unit on Ski-Doo Renegade 850 E-Tec Adrenaline snowmobiles built between 2017 and 2026, handling the high-current switching that sends power to the starter motor.

Overview

This starter relay and solenoid is built for the Ski-Doo Renegade 850 E-Tec Adrenaline and handles the heavy electrical load of engaging the starter motor on every push of the button. The starter relay is a direct-fit replacement for worn or failed solenoids on 2017 through 2026 models. Riders and shops choose this starter relay for its reliable contact action in cold-weather starting conditions.

Built For Performance

• Heavy-duty copper contacts for consistent high-current transfer
• Sealed housing resists moisture, snow, and spray intrusion
• Direct-fit mounting matched to the factory solenoid footprint
• Rated for the amperage draw of the 850 E-Tec starter circuit
• Weather-resistant terminals for dependable cold-start engagement
• Drop-in replacement with no wiring modifications required

Fits These Machines

• for Ski-Doo Renegade 850 E-Tec Adrenaline 2017
• for Ski-Doo Renegade 850 E-Tec Adrenaline 2018
• for Ski-Doo Renegade 850 E-Tec Adrenaline 2019
• for Ski-Doo Renegade 850 E-Tec Adrenaline 2020
• for Ski-Doo Renegade 850 E-Tec Adrenaline 2021
• for Ski-Doo Renegade 850 E-Tec Adrenaline 2022
• for Ski-Doo Renegade 850 E-Tec Adrenaline 2023
• for Ski-Doo Renegade 850 E-Tec Adrenaline 2024
• for Ski-Doo Renegade 850 E-Tec Adrenaline 2025
• for Ski-Doo Renegade 850 E-Tec Adrenaline 2026

On-The-Job Use

• Replacing a solenoid that clicks but will not crank the engine
• Trailside repairs when the starter circuit fails in cold conditions
• Seasonal maintenance before deep-winter riding
• Shop service on high-mileage Renegade 850 E-Tec Adrenaline sleds

Specs At A Glance

Good To Know

Q: How do I know the relay is the problem and not the starter? A: A solenoid that clicks without cranking, or a starter that stays silent with good battery voltage, points to the relay. Test voltage at the starter terminal while cranking to confirm before replacing.

Q: Can I install this relay myself? A: Yes, it mounts in the factory location and connects with the existing wiring. Disconnect the battery first, then transfer the cables to the matching terminals on the new unit.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.