Std Bore Piston Rings for Ski-Doo Elite 450 1978-1980
Std Bore Piston Rings for Ski-Doo Elite 450 1978-1980
Couldn't load pickup availability
Std Bore Piston Rings for Ski-Doo Elite 450
These standard bore piston rings rebuild the top end of the Ski-Doo Elite 450 engine, restoring compression and oil control for the 1978 through 1980 model years.
Overview
These standard bore piston rings are a direct replacement set for the Ski-Doo Elite 450 engine. They seal the piston to the cylinder wall to restore compression and control oil, making them a smart choice for a top-end refresh. Sold as a set sized to the factory standard bore.
Built For Performance
- Standard bore sizing matches the original cylinder dimensions for a drop-in fit
- Ring set designed for two-stroke snowmobile engines of this displacement
- Restores compression lost to worn or stuck rings
- Helps reduce blow-by and oil consumption
- Suited to routine top-end rebuilds and re-ring jobs
Fits These Machines
- for Ski-Doo Elite 450 (1978-1980)
On-The-Job Use
- Top-end rebuilds on vintage Ski-Doo Elite 450 sleds
- Restoring compression on high-hour engines
- Refresh jobs during piston or cylinder service
- Seasonal maintenance on classic snowmobiles
Specs At A Glance
| Bore Size | Standard bore |
| Fits Model | for Ski-Doo Elite 450 |
| Model Years | 1978-1980 |
| Type | Piston ring set |
Good To Know
Q: Do I need to hone the cylinder when installing new rings? A: A light hone helps new rings seat properly and is recommended on most rebuilds. Check bore wear and taper before ordering.
Q: Are these rings sold as a set for one piston? A: These standard bore piston rings are intended for one piston assembly. Confirm the quantity you need against your engine before ordering.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
