Std Bore Piston Rings for Ski-Doo Formula MX 463 cc 1985-1995
Std Bore Piston Rings for Ski-Doo Formula MX 463 cc 1985-1995
Couldn't load pickup availability
Std Bore Piston Rings for Ski-Doo Formula MX
These standard bore piston rings are replacement sealing components that restore compression in the 463 cc engine used in the Ski-Doo Formula MX, helping the piston maintain a proper seal against the cylinder wall.
Overview
This standard bore piston ring set is made for the Ski-Doo Formula MX powered by the 463 cc engine. The rings seat against the cylinder wall to help hold compression and control oil at the piston. A sound choice for rebuilders and riders refreshing a top end on this classic Ski-Doo snowmobile engine.
Built For Performance
- Standard bore sizing to match the original cylinder diameter
- Ring set configured for the 463 cc piston assembly
- Designed to help restore compression during a top-end refresh
- Helps control oil at the piston skirt and cylinder wall
Fits These Machines
- for Ski-Doo Formula MX 463 cc, 1985-1995
On-The-Job Use
- Top-end rebuilds on the 463 cc engine
- Refreshing compression on higher-mileage machines
- Routine piston and ring service
Specs At A Glance
| Bore Type | Standard |
| Displacement | 463 cc |
| Component | Piston rings |
Good To Know
Q: Should I check ring end gap before installing? A: Yes, ring end gap should be measured in the cylinder before assembly to confirm the rings fall within spec. Gap should be verified against the service manual for the 463 cc engine.
Q: Are these rings for standard bore only? A: These are standard bore rings and are not intended for bored-over cylinders. Confirm your cylinder is at standard bore before ordering.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
