Skip to product information
1 of 1

Std Bore Piston Rings for Ski-Doo Formula ST 463 cc 1994

Std Bore Piston Rings for Ski-Doo Formula ST 463 cc 1994

Regular price $32.99
Regular price Sale price $32.99
Sale Sold out
Quantity

Std Bore Piston Rings for Ski-Doo Formula ST

These standard bore piston rings are replacement sealing components that restore compression in the 463 cc engine used in the 1994 Ski-Doo Formula ST, helping the piston maintain a proper seal against the cylinder wall.

Overview

This standard bore piston ring set is made for the Ski-Doo Formula ST powered by the 463 cc engine. The rings seat against the cylinder wall to help hold compression and control oil at the piston. A sound choice for rebuilders and riders refreshing a top end on this Ski-Doo snowmobile engine.

Built For Performance

  • Standard bore sizing to match the original cylinder diameter
  • Ring set configured for the 463 cc piston assembly
  • Designed to help restore compression during a top-end refresh
  • Helps control oil at the piston skirt and cylinder wall

Fits These Machines

  • for Ski-Doo Formula ST 463 cc, 1994

On-The-Job Use

  • Top-end rebuilds on the 463 cc engine
  • Refreshing compression on higher-mileage machines
  • Routine piston and ring service

Specs At A Glance

Bore Type Standard
Displacement 463 cc
Component Piston rings

Good To Know

Q: Should I check ring end gap before installing? A: Yes, ring end gap should be measured in the cylinder before assembly to confirm the rings fall within spec. Gap should be verified against the service manual for the 463 cc engine.

Q: Are these rings for standard bore only? A: These are standard bore rings and are not intended for bored-over cylinders. Confirm your cylinder is at standard bore before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details