Std Bore Piston Rings for Ski-Doo MXZ 500 1998-1999
Std Bore Piston Rings for Ski-Doo MXZ 500 1998-1999
Couldn't load pickup availability
Std Bore Piston Rings for Ski-Doo MXZ 500 1998-1999
Standard bore piston rings for the Ski-Doo MXZ 500 1998-1999, sealing the cylinder so compression holds and the 500 twin keeps its snap on the trail.
Overview
These standard bore piston rings for Ski-Doo MXZ 500 1998-1999 fit the stock bore and are made for top end service on the 1998-1999 MXZ 500. A fresh set of Ski-Doo MXZ 500 piston rings helps restore compression, cut blow-by, and get the engine back to a clean, strong-running state.
Built For Performance
- Standard bore sizing so no overbore or cylinder machining is needed
- Ring set built for two-stroke snowmobile heat cycles and cold starts
- Helps control blow-by and hold compression under load
- Sized for the 1998-1999 Ski-Doo MXZ 500 top end
- Sold as a ring set for piston reassembly during rebuild
Fits These Machines
- for Ski-Doo MXZ 500 1998
- for Ski-Doo MXZ 500 1999
On-The-Job Use
- Top end rebuilds after a low compression check
- Routine maintenance on high-mileage MXZ 500 sleds
- Restoring ring seal after piston inspection or replacement
- Trail riding where consistent compression matters
Specs At A Glance
| Bore Size | Standard |
| Machine | for Ski-Doo MXZ 500 |
| Model Years | 1998-1999 |
| Component | Piston Rings |
Good To Know
Q: Should I measure the cylinder before installing these rings? A: Yes, checking bore wear and ring end gap confirms the cylinder is still within standard spec before assembly.
Q: Are these rings sold for one piston or the full engine? A: Confirm the quantity you need for your rebuild, since a twin-cylinder top end typically uses more than one ring set.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
