Std Bore Piston Rings for Ski-Doo Skandic WT 500 1999-2000
Std Bore Piston Rings for Ski-Doo Skandic WT 500 1999-2000
Couldn't load pickup availability
Std Bore Piston Rings for Ski-Doo Skandic WT 500
These standard bore piston rings are a direct replacement set for the Ski-Doo Skandic WT 500, renewing compression and sealing the combustion chamber for reliable two-stroke power.
Overview
These standard bore piston rings for Ski-Doo Skandic WT 500 snowmobiles restore the seal between piston and cylinder wall for consistent compression. As a standard bore piston ring set, they are sized to the factory bore for a straightforward fit. They suit owners refreshing the top end on a 1999 or 2000 Skandic WT 500.
Built For Performance
- Standard bore sizing matched to the factory cylinder diameter
- Ring set configured for a complete piston ring replacement
- Spring tension designed to maintain consistent cylinder wall contact
- Heat-treated metal construction for the demands of two-stroke operation
Fits These Machines
- for Ski-Doo Skandic WT 500, 1999
- for Ski-Doo Skandic WT 500, 2000
On-The-Job Use
- Top end rebuilds on 1999 to 2000 Skandic WT 500 sleds
- Restoring compression after ring wear
- Routine piston servicing during engine freshening
Specs At A Glance
| Bore Size | Standard |
| Component | Piston Rings |
| Vehicle | for Ski-Doo Skandic WT 500 |
| Model Years | 1999-2000 |
Good To Know
Q: Are these rings sold as a single ring or a full set? A: This listing covers a standard bore piston ring set for one piston, sized for the Skandic WT 500 engine. Confirm the quantity you need against your rebuild plan before ordering.
Q: Do I need to hone the cylinder before installing new rings? A: A light hone helps new rings seat against the cylinder wall. Inspect the bore for scoring or taper and measure it before installation.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
