Skip to product information
1 of 1

Std Bore Pistons Pair for Ski-Doo Skandic 500 1995-2000 Snowmobile

Std Bore Pistons Pair for Ski-Doo Skandic 500 1995-2000 Snowmobile

Regular price $186.99
Regular price Sale price $186.99
Sale Sold out
Quantity

Std Bore Pistons for Ski-Doo Skandic 500

This pair of standard bore pistons is a direct replacement engine component for the Ski-Doo Skandic 500, sized to the factory bore so you can rebuild the top end without overboring.

Overview

These standard bore pistons restore compression and reliability to the Ski-Doo Skandic 500 engine. Sold as a matched pair, they are intended for riders and mechanics rebuilding a worn or damaged top end on 1995 through 2000 models. Each piston is machined to standard bore dimensions so it drops into an unmodified cylinder.

Built For Performance

  • Standard bore sizing keeps the original cylinder intact with no machining required
  • Sold as a pair so both cylinders can be refreshed in one rebuild
  • Machined crown and skirt geometry matched to the Skandic 500 engine
  • Cast construction suited to the load and heat of a utility snowmobile engine
  • Ring grooves cut to accept standard replacement rings

Fits These Machines

  • for Ski-Doo Skandic 500, 1995
  • for Ski-Doo Skandic 500, 1996
  • for Ski-Doo Skandic 500, 1997
  • for Ski-Doo Skandic 500, 1998
  • for Ski-Doo Skandic 500, 1999
  • for Ski-Doo Skandic 500, 2000

On-The-Job Use

  • Top end rebuild after a seized or scored piston
  • Refreshing compression on a high-hour utility sled
  • Routine engine service on work machines used for hauling and trail grooming
  • Seasonal maintenance before winter riding

Specs At A Glance

Bore Size Standard bore
Quantity Pair
Application for Ski-Doo Skandic 500, 1995-2000

Good To Know

Q: Do I need to bore my cylinders to install these pistons? A: No. These are standard bore pistons intended for cylinders still at original factory dimensions. If your cylinder is scored or worn past spec, it will need machining and an oversize piston instead.

Q: Should I replace rings and wrist pins at the same time? A: Yes, a rebuild should include new rings and wrist pin components along with the pistons. Reusing worn rings with fresh pistons can cost compression and shorten the life of the rebuild.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details