Skip to product information
1 of 1

Std Bore Pistons Piston for Arctic Cat Jag 340 1987-1998

Std Bore Pistons Piston for Arctic Cat Jag 340 1987-1998

Regular price $164.99
Regular price Sale price $164.99
Sale Sold out
Quantity

Std Bore Pistons / Piston for Arctic Cat Jag 340

This standard bore piston and piston assembly is a direct-fit replacement component for Arctic Cat Jag 340 cc snowmobile engines produced between 1987 and 1998, restoring lost compression and dependable top-end performance.

Overview

This std bore piston for Arctic Cat Jag 340 is built to factory sizing so it drops into an unmodified cylinder without boring or honing oversize. Each piston for Arctic Cat Jag 340 is manufactured to deliver proper ring seal, quiet operation, and consistent combustion across the rpm range. It suits riders and independent shops rebuilding a tired 340 cc top end for trail use.

Built For Performance

  • Standard bore sizing that matches the original cylinder dimensions
  • Precision-machined skirt profile for smooth piston-to-cylinder clearance
  • Ring grooves cut to accept standard replacement rings
  • Wrist pin bore machined for a correct fit on the connecting rod
  • Built from a high-silicon aluminum alloy for thermal stability
  • Coated skirt surface to reduce friction and scuffing on cold starts

Fits These Machines

  • for Arctic Cat Jag 340, model years 1987 through 1998
  • for Arctic Cat Jag 340 cc fan-cooled snowmobile engines

On-The-Job Use

  • Top-end rebuilds after a piston seizure or scored cylinder
  • Routine freshening of a high-mileage 340 cc trail engine
  • Restoring compression on a classic Jag used for ice fishing and trail rides
  • Shop work where a stock bore replacement keeps the original cylinder in service

Specs At A Glance

Part Type Piston / Piston Assembly
Bore Size Standard bore
Engine Displacement 340 cc
Vehicle Fitment for Arctic Cat Jag 340, 1987-1998

Good To Know

Q: Do I need to bore my cylinder to install this piston? A: No, this is a standard bore piston, so it is meant to run in a cylinder that is already at stock dimensions. If your cylinder is scored or out of round, it will need machining and an oversize piston instead.

Q: Should pistons and rings be replaced together? A: Yes, fitting new rings to a new piston is standard practice for a top-end rebuild. Reusing old rings on a fresh piston usually prevents the rings from seating correctly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details