Std Piston Rings for Arctic Cat Mountain Cat 500 2001-2002
Std Piston Rings for Arctic Cat Mountain Cat 500 2001-2002
Couldn't load pickup availability
Std Piston Rings for Arctic Cat Mountain Cat 500
These standard bore piston rings are replacement sealing components for the Arctic Cat Mountain Cat 500 snowmobile engine, sized to original bore dimensions so the piston can hold proper compression against the cylinder wall.
Overview
These Std Piston Rings are built to restore compression in the Arctic Cat Mountain Cat 500 engine. Each ring set is sized to standard bore so it installs on the stock piston without cylinder overboring. A sensible pick for riders rebuilding a top end on the Mountain Cat 500 or replacing worn rings before the snow flies.
Built For Performance
- Sized to standard bore dimensions for a direct fit on the stock piston
- Designed to seal combustion pressure between piston and cylinder wall
- Helps bring compression back in a tired top end
- Suited to the demands of the two-stroke Mountain Cat 500 engine
- Supplied as a set to service the piston during a rebuild
Fits These Machines
- for Arctic Cat Mountain Cat 500, 2001
- for Arctic Cat Mountain Cat 500, 2002
On-The-Job Use
- Top end rebuilds on the Mountain Cat 500 snowmobile
- Compression refresh after heavy mountain riding
- Routine engine maintenance when rings show wear
Specs At A Glance
| Type | Piston rings |
| Bore Size | Standard |
| Machine | for Arctic Cat Mountain Cat 500 |
| Years | 2001-2002 |
Good To Know
Q: Will these rings fit an overbored cylinder? A: No, these are standard bore rings meant for a stock cylinder and piston that have not been overbored.
Q: Is it best to replace all rings at once? A: Replacing the full set together keeps sealing even around the piston during a top end rebuild.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
