Std Piston Rings for Arctic Cat Powder Special 500 1999-2000
Std Piston Rings for Arctic Cat Powder Special 500 1999-2000
Couldn't load pickup availability
Std Piston Rings for Arctic Cat Powder Special 500
These standard bore piston rings are replacement sealing components for the Arctic Cat Powder Special 500 snowmobile engine, sized to original bore dimensions so the piston can maintain proper compression against the cylinder wall.
Overview
These Std Piston Rings are made to restore compression in the Arctic Cat Powder Special 500 engine. Each ring set is sized to standard bore so it drops onto the stock piston without any cylinder overboring. A practical choice for riders rebuilding a top end on the Powder Special 500 or refreshing worn rings before the season starts.
Built For Performance
- Sized to standard bore dimensions for a direct fit on the stock piston
- Designed to seal combustion pressure between piston and cylinder wall
- Helps restore lost compression in a worn top end
- Suited to the two-stroke demands of the Powder Special 500 engine
- Sold as a set to service the piston during a rebuild
Fits These Machines
- for Arctic Cat Powder Special 500, 1999
- for Arctic Cat Powder Special 500, 2000
On-The-Job Use
- Top end rebuilds on the Powder Special 500 snowmobile
- Compression refresh after a season of hard riding
- Routine engine maintenance when rings show wear
Specs At A Glance
| Type | Piston rings |
| Bore Size | Standard |
| Machine | for Arctic Cat Powder Special 500 |
| Years | 1999-2000 |
Good To Know
Q: Do I need to bore the cylinder to use these rings? A: No, these are standard bore rings intended for a stock cylinder and piston that have not been overbored.
Q: Should rings be replaced as a set? A: Replacing the full set at once keeps sealing consistent around the piston during a top end rebuild.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
