Std Piston Rings for Arctic Cat Triple Touring 600 1999-2000

Std Piston Rings for Arctic Cat Triple Touring 600

These standard bore piston rings for Arctic Cat Triple Touring 600 models from 1999 to 2000 are direct replacement rings built to restore compression in the top end.

Overview

These Std Piston Rings are replacement rings for the 600 triple engine used in Arctic Cat Triple Touring snowmobiles from 1999 to 2000. They seal the piston to the cylinder wall so combustion pressure stays where it belongs and the engine holds the compression it needs to run right. A smart pick for anyone doing a top end rebuild on an Arctic Cat Triple Touring 600.

Built For Performance

• Standard bore sizing
• Sold as a ring set
• Built for the 600 triple engine
• Restores sealing between piston and cylinder
• Replacement rings for a top end rebuild

Fits These Machines

• for Arctic Cat Triple Touring 600, 1999
• for Arctic Cat Triple Touring 600, 2000

On-The-Job Use

• Top end rebuilds
• Compression restoration
• Seasonal engine maintenance

Specs At A Glance

Good To Know

Q: What does standard bore mean? A: Standard bore rings match the factory cylinder size, so they are used when the cylinder has not been bored oversize. Confirm your cylinder is still at standard bore before ordering.

Q: Do rings come as a single ring or a set? A: Ring sets are normally sold as a full set for the piston, so check the listing quantity against your piston count. Make sure the set covers everything you need before you start the rebuild.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.