Std Piston Rings for Ski-Doo Freestyle Session 550 2007
Std Piston Rings for Ski-Doo Freestyle Session 550 2007
Couldn't load pickup availability
Std Piston Rings for Ski-Doo Freestyle Session 550
Standard-bore piston rings for the Ski-Doo Freestyle Session 550, sized for the 550 engine and built to restore compression in the 2007 model.
Overview
These std piston rings for Ski-Doo Freestyle Session 550 sleds are the standard replacement set for the 550 engine in the 2007 model year. They seal against the cylinder wall to hold combustion pressure and control oil at the piston face. A solid choice for a top-end refresh on a Freestyle Session 550 that needs compression restored.
Built For Performance
- Standard bore sizing to match stock cylinders without machining
- Ring set configured for the 550 two-stroke piston
- Designed to restore compression and improve starting
- Built to control cylinder wall oil and reduce blow-by
- Direct fit replacement for worn or stuck rings
Fits These Machines
- for Ski-Doo Freestyle Session 550 2007
On-The-Job Use
- Top-end rebuilds on Freestyle Session 550 sleds
- Compression recovery on high-hour machines
- Ring replacement during piston or cylinder refresh
- Seasonal maintenance before winter riding
Specs At A Glance
| Ring Type | Standard bore piston rings |
| Engine | 550 two-stroke |
| Model Fit | for Ski-Doo Freestyle Session 550 |
| Year | 2007 |
Good To Know
Q: Do I need to hone the cylinder before fitting new rings? A: A light hone and a check of cylinder taper are recommended so the new rings can seat properly. Inspect the piston and bore before assembly.
Q: Are these rings for one piston or both? A: Confirm the quantity listed before ordering so you have the ring set needed for your rebuild. Ring sets are typically sold per piston.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
