Std Piston Rings for Ski-Doo Legend 550 2003-2004 Models
Std Piston Rings for Ski-Doo Legend 550 2003-2004 Models
Couldn't load pickup availability
Std Piston Rings for Ski-Doo Legend 550
Standard-bore piston rings for the Ski-Doo Legend 550 that rebuild compression and oil control on the 550cc twin.
Overview
These standard piston rings for Ski-Doo Legend 550 snowmobiles replace worn rings in the stock bore. The set seals the piston to the cylinder wall, bringing back compression and managing oil on the bore surface. A practical choice for riders refreshing the top end of a 550 twin.
Built For Performance
- Standard bore sizing for stock cylinders
- Ring set matched to the 550cc twin piston
- Restores lost compression from worn rings
- Helps reduce oil consumption and blow-by
- Direct replacement for the original rings
- Fits a routine top-end service
Fits These Machines
- for Ski-Doo Legend 550, 2003-2004
On-The-Job Use
- Top-end rebuilds on the 550 twin
- Compression recovery on older engines
- Seasonal trail maintenance
- Piston replacement service
Specs At A Glance
| Ring Type | Standard piston rings |
| Bore Size | Standard |
| Engine | 550cc twin |
Good To Know
Q: Is honing required before fitting new rings? A: A light hone and bore inspection help the new rings seat and is advised during any ring replacement. Check cylinder wear limits before assembly.
Q: Are these rings for stock bore only? A: Yes, they are standard-size rings and do not suit an overbored cylinder. Confirm your bore size before ordering.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
