Std Pistons for Ski-Doo MXZ 800 REV 2002 PAIR
Std Pistons for Ski-Doo MXZ 800 REV 2002 PAIR
Couldn't load pickup availability
Std Pistons; PAIR for Ski-Doo
This pair of standard bore pistons is made for the Ski-Doo MXZ 800 REV 2002 snowmobile engine, restoring compression and power to a top end rebuild.
Overview
These standard pistons for Ski-Doo are a direct replacement set for the MXZ 800 REV 2002 engine. Each piston is machined to factory bore size so the top end goes back together without overboring. This pair suits riders and mechanics rebuilding the 800 REV mill for trail and mountain use.
Built For Performance
- Standard bore sizing matches the original MXZ 800 REV cylinder dimensions
- Sold as a matched pair for a complete top end refresh
- Machined piston crown and skirt for consistent combustion and sealing
- Ring grooves cut to accept standard replacement rings
- Wrist pin bore sized for the factory connecting rod assembly
Fits These Machines
- for Ski-Doo MXZ 800 REV 2002
On-The-Job Use
- Top end rebuilds after a piston seizure or loss of compression
- Seasonal maintenance on high mileage 800 REV engines
- Trail and backcountry riding where reliable compression matters
- Shop rebuilds where factory bore size must be retained
Specs At A Glance
| Part Type | Standard bore piston pair |
| Bore Size | Standard |
| Quantity | Pair |
Good To Know
Q: Do I need to measure the cylinder before installing these pistons? A: Yes, always check cylinder bore and taper against the service spec before fitment. Worn plating or out of round bores can cause poor sealing even with new standard pistons.
Q: Should rings and wrist pin bearings be replaced at the same time? A: It is good practice to fit new rings, clips, and bearings during any top end rebuild. Reusing worn hardware can shorten the life of the new pistons.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
