Suspension Control Arm Bushings-Set of 2 For Audi A6 Quattro VW Passat Front Up

Suspension Control Arm Bushings for Audi A6 Quattro and VW Passat

This set of 2 front upper suspension control arm bushings restores steering precision and absorbs road vibration on compatible Audi A6 Quattro and VW Passat models.

Overview

These suspension control arm bushings for Audi A6 Quattro and VW Passat vehicles replace worn factory bushings to tighten front-end response. Each set of 2 control arm bushings cushions the arm-to-chassis pivot, reducing clunks and vague steering. Built as a direct-fit replacement for drivers servicing high-mileage front suspensions.

Built For Performance

• Rubber construction isolates road noise and vibration from the cabin
• Set of 2 covers both front upper control arm positions
• Direct-fit dimensions match the original bushing footprint
• Resists cracking and compression set under repeated load
• Restores factory steering feel and alignment geometry

Fits These Machines

• for Audi A6 Quattro (front upper position)
• for Volkswagen Passat (front upper position)

On-The-Job Use

• Front suspension refresh on high-mileage Audi and VW cars
• Replacing cracked or collapsed bushings after inspection
• Alignment service when control arm play is detected
• Ride quality restoration on daily-driven sedans

Specs At A Glance

Good To Know

Q: Do I need an alignment after installing these bushings? A: Yes, replacing control arm bushings changes suspension geometry, so a professional alignment is recommended afterward. Q: Can these be pressed in with hand tools? A: A press or bushing driver is typically required to seat these bushings correctly in the control arm.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.