Suspension Spring Retainer for Ski-Doo Renegade 800R E-Tec Back Country 2011-201
Suspension Spring Retainer for Ski-Doo Renegade 800R E-Tec Back Country 2011-201
Couldn't load pickup availability
Suspension Spring Retainer for Ski-Doo
This suspension spring retainer is a replacement component that secures the spring on the shock assembly for Ski-Doo Renegade 800R E-Tec Back Country snowmobiles from 2011-2013.
Overview
This suspension spring retainer is a direct-fit replacement that keeps your shock spring properly seated on the Ski-Doo Renegade 800R E-Tec Back Country. It holds the spring in position under load so your rear suspension performs as designed. A smart pick for riders maintaining or rebuilding their 2011-2013 Renegade suspension.
Built For Performance
- Precision-formed to match the original retainer profile for a secure spring seat
- Durable construction built to withstand repeated suspension cycling
- Holds spring alignment under compression for consistent shock performance
- Simple drop-in replacement for worn or damaged retainers
- Designed specifically for the 2011-2013 Ski-Doo Renegade 800R E-Tec Back Country
Fits These Machines
- for Ski-Doo Renegade 800R E-Tec Back Country 2011
- for Ski-Doo Renegade 800R E-Tec Back Country 2012
- for Ski-Doo Renegade 800R E-Tec Back Country 2013
On-The-Job Use
- Rear suspension shock spring service and rebuilds
- Backcountry riding where consistent suspension response matters
- Routine maintenance on high-mileage Renegade sleds
- Restoring proper spring tension after a retainer wears out
Specs At A Glance
| Part Type | Suspension Spring Retainer |
| Fitment | for Ski-Doo Renegade 800R E-Tec Back Country |
| Model Years | 2011-2013 |
Good To Know
Q: Will this fit my 800R E-Tec Back Country? A: Yes, this retainer is listed for the 2011-2013 Renegade 800R E-Tec Back Country model. Confirm your specific model year and trim before ordering.
Q: Do I need any special tools to install it? A: Installation typically requires compressing the shock spring to remove and reseat the retainer. A spring compressor and basic hand tools are usually sufficient for the job.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
