Tachometer Cable for Honda CB360G 1974 Tach CB 360G

Tachometer Cable for Honda CB360G

This tachometer cable is a replacement drive cable that connects the tachometer gauge to the engine of a 1974 Honda CB360G, transferring rotational signal so the gauge reads engine RPM accurately.

Overview

This tachometer cable is a direct replacement for the original cable on the 1974 Honda CB360G, routing from the engine tach drive up to the gauge cluster to keep RPM readings steady and accurate. It suits riders restoring a classic CB360G or replacing a worn, binding, or broken tachometer cable. The cable is built to match the original routing and connection points.

Built For Performance

• Inner cable spins freely within the sheath to deliver consistent RPM signal
• Correct end fittings for the tachometer gauge and engine drive on the CB360G
• Flexible outer sheath bends to follow the factory cable routing without kinking
• Outer jacket resists oil, moisture, and road grime for long service life
• Length matched to the original cable for a drop-in replacement fit

Fits These Machines

• for Honda CB360G (1974)

On-The-Job Use

• Restoring a vintage CB360G to working gauge condition
• Replacing a snapped or binding tachometer cable during routine service
• Bringing a barn-find or project bike back to roadworthy status
• Routine maintenance on classic Honda twins

Specs At A Glance

Good To Know

Q: How do I know if my tachometer cable needs replacing? A: A jumping, twitching, or dead tachometer needle usually points to a worn or broken cable, and a cable that binds or makes noise when spun by hand should also be replaced.

Q: Does this cable require lubrication before installation? A: A light coat of cable grease on the inner cable during installation helps it run smoothly and extends its service life.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.