Temp Sensor Connector Repair Kit for Arctic Cat Pantera 3000 2016-2019
Temp Sensor Connector Repair Kit for Arctic Cat Pantera 3000 2016-2019
Couldn't load pickup availability
Temp Sensor Connector Repair Kit for Arctic Cat Pantera 3000
This temp sensor connector repair kit restores the electrical connection on Arctic Cat Pantera 3000 snowmobiles from 2016 through 2019, letting the temperature sensor communicate correctly with the engine management system.
Overview
This temp sensor connector repair kit is made for Arctic Cat Pantera 3000 machines from 2016 to 2019 that need a fresh, secure plug at the temperature sensor. The kit replaces worn or corroded connector hardware so the signal stays clean and the sled runs as it should. Riders and mechanics working on these snowmobiles will find it a practical fix for intermittent gauge readings or fault codes.
Built For Performance
- Direct-fit replacement connector designed for the temperature sensor circuit
- Restores reliable electrical contact between sensor and harness
- Resists corrosion and vibration common to snowmobile engine bays
- Includes the connector components needed for a clean repair
- Built to match the original connection style for straightforward installation
Fits These Machines
- for Arctic Cat Pantera 3000, 2016
- for Arctic Cat Pantera 3000, 2017
- for Arctic Cat Pantera 3000, 2018
- for Arctic Cat Pantera 3000, 2019
On-The-Job Use
- Repairing a damaged temp sensor plug during routine maintenance
- Fixing intermittent temperature readings on the trail
- Restoring factory-style wiring after corrosion or rodent damage
- Servicing the engine harness in a home or shop garage
Specs At A Glance
| Part Type | Temp Sensor Connector Repair Kit |
| Compatible Model | Pantera 3000 |
| Model Years | 2016-2019 |
| Brand Fit | for Arctic Cat |
Good To Know
Q: What does this repair kit fix? A: It replaces the connector at the temperature sensor so the sensor signal reaches the sled's electrical system without interruption. It addresses loose, corroded, or damaged plug hardware.
Q: Do I need any special tools? A: Basic hand tools for harness and connector work are typically enough for this repair. Crimping or soldering may be needed depending on how the original connector is removed.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
