Tether Switch and Cap for Polaris Dragon 600 SP 2009

Tether Switch and Cap for Polaris

The Tether Switch and Cap for Polaris is a safety cut-off assembly that attaches to the rider and shuts the engine down if the rider separates from the machine, replacing the worn or missing original unit on your snowmobile.

Overview

This Tether Switch and Cap for Polaris gives you a direct replacement for the factory engine kill tether on your sled. The tether switch and cap keep the safety shutdown circuit working so the engine stops the moment the cord is pulled. It suits riders maintaining or restoring a Polaris Dragon 600 SP who want dependable safety hardware.

Built For Performance

• Complete assembly with switch body and cap included
• Engine kill function activates when the tether cord is pulled free
• Direct replacement for the stock tether switch position
• Designed for snowmobile electrical and safety circuits
• Simple plug-in style installation on the factory wiring

Fits These Machines

• for Polaris Dragon 600 SP, 2009

On-The-Job Use

• Trail riding where a working safety tether is required
• Mountain and deep snow riding where rider separation is a risk
• Restoring a used sled to safe operating condition
• Routine replacement of a worn or damaged tether switch

Specs At A Glance

Good To Know

Q: How does the tether switch shut the engine down? A: The cap stays attached to the rider by a cord, and when the cord is pulled the switch breaks the kill circuit and stops the engine. This is the standard safety setup on snowmobiles.

Q: Do I need to change any wiring to install it? A: It is built as a direct replacement for the factory tether switch on the listed model. Confirm the connector and mounting match your sled before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.