Tether Switch and Cap for Polaris Dragon 700 IQ 2008

Tether Switch and Cap for Polaris Dragon 700 IQ

This tether switch and cap for Polaris Dragon 700 IQ is a safety cutoff component that links to the ignition circuit so the engine shuts off when the lanyard is released.

Overview

The tether switch and cap for Polaris Dragon 700 IQ is a replacement safety device that stops the engine when the rider leaves the machine. This tether switch and cap helps prevent a runaway sled after a fall or spill. Owners of a 2008 Dragon 700 IQ who need to restore the kill-switch function will find this tether switch and cap a practical fit.

Built For Performance

• Cut-off contacts that interrupt the ignition circuit when the cap is pulled
• Weather-resistant cap and body built for cold, wet snow conditions
• Direct-fit connector for a 2008 Dragon 700 IQ harness
• Compact shape suited to handlebar and dash mounting points
• Durable housing that withstands repeated lanyard pulls

Fits These Machines

• for Polaris Dragon 700 IQ, 2008

On-The-Job Use

• Replacing a broken or intermittent tether switch on a 2008 Dragon 700 IQ
• Trail riding where rider separation must stop the engine
• Routine sled maintenance and safety checks
• Restoring the kill-switch function after a failed cap or worn contact

Specs At A Glance

Good To Know

Q: How does a tether switch work? A: The lanyard clips to the rider and the cap sits on the switch, so if the rider separates from the sled the cap pulls free and cuts the ignition. This shuts the engine down before the machine can travel far without a rider.

Q: Can I install this on my own? A: Basic hand tools and a look at your service manual are usually enough to replace a tether switch and cap. Confirm your model and year before ordering to be sure the connector matches.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.