Tether Switch and Cap for Polaris Dragon 800 SP 2009

Tether Switch and Cap for Polaris Dragon 800 SP

This tether switch and cap for Polaris Dragon 800 SP is a safety cutoff component that connects to your snowmobile's ignition system so the engine stops when the lanyard is pulled.

Overview

The tether switch and cap for Polaris Dragon 800 SP is a replacement safety device that shuts down the engine when the rider is separated from the machine. This tether switch and cap keeps your snowmobile from running away after a fall. Riders and mechanics servicing a 2009 Dragon 800 SP will find this tether switch and cap a practical replacement choice.

Built For Performance

• Safety cut-off contacts that break the ignition circuit when the lanyard is pulled
• Weather-resistant cap and housing suited to cold, snowy conditions
• Direct-fit connector for a 2009 Dragon 800 SP harness
• Compact body sized for handlebar and dash mounting locations
• Sturdy construction that holds up to repeated lanyard pulls

Fits These Machines

• for Polaris Dragon 800 SP, 2009

On-The-Job Use

• Replacing a cracked or failed tether switch on a 2009 Dragon 800 SP
• Trail and mountain riding where rider separation must stop the engine
• Routine sled maintenance and safety inspections
• Restoring the kill-switch function after a broken cap or worn contact

Specs At A Glance

Good To Know

Q: How does a tether switch work? A: The lanyard clips to the rider and to the switch, so if the rider separates from the sled the cap pulls free and cuts the ignition. This stops the engine before the machine can travel far without a rider.

Q: Can I install this on my own? A: Basic hand tools and a look at your service manual are usually enough to swap a tether switch and cap. Check your model and year before ordering to confirm the connector matches.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.