Tether Switch and Cap for Polaris Indy 800 HO XC 2019-2020

Tether Switch and Cap for Polaris Indy 800 HO XC

This tether switch and cap is a safety cut-off device for Polaris Indy 800 HO XC snowmobiles, built to stop the engine when the rider detaches from the machine.

Overview

This tether switch and cap assembly gives your Polaris Indy 800 HO XC a working safety shutdown at the handlebar. The tether switch and cap pairs with a lanyard so the engine cuts out the moment the rider separates from the sled. It is a direct replacement choice for riders maintaining their machine's safety system.

Built For Performance

• Engine kill function activates when the tether is pulled from the cap
• Cap and switch supplied as a matched assembly for consistent engagement
• Mounts at the handlebar position used on the Indy 800 HO XC
• Straightforward wiring to the existing kill circuit
• Construction suited to cold, wet snowmobile conditions

Fits These Machines

• for Polaris Indy 800 HO XC, 2019
• for Polaris Indy 800 HO XC, 2020

On-The-Job Use

• Trail riding where rider separation from the sled must cut the engine
• Mountain and deep snow riding where a fall can leave a sled running
• Replacing a worn or damaged tether cap on a used snowmobile
• Pre-season safety component refresh

Specs At A Glance

Good To Know

Q: How does the tether switch stop the engine? A: The cap holds a switch that keeps the kill circuit in its run state while the lanyard is attached to the rider. When the lanyard pulls free, the circuit changes state and the engine shuts off.

Q: Does this cover both listed model years? A: This listing is set up for the Polaris Indy 800 HO XC, 2019-2020. Fitment can still depend on serial number, so confirm your machine's application before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.