Tether Switch and Cap for Polaris Rush 600 LX 2011

Tether Switch and Cap for Polaris

The Tether Switch and Cap for Polaris is a safety kill-switch assembly that cuts engine ignition the moment the lanyard is pulled free, and it is a direct replacement for the factory tether switch on the listed Polaris snowmobile models.

Overview

This tether switch and cap for Polaris keeps your snowmobile shut down the instant you separate from the machine, cutting spark before a runaway sled can travel. It is built as a drop-in replacement for the stock tether switch, so riders dealing with a worn, sticking, or broken lanyard cap can restore reliable shutdown protection without hunting for discontinued parts. The tether switch and cap for Polaris is aimed at trail riders, mountain riders, and anyone maintaining an older Polaris Rush chassis.

Built For Performance

• Kill-switch design breaks ignition contact when the lanyard is pulled from the cap
• Replacement-style cap and switch assembly built to match the original mounting point
• Corrosion-resistant contacts suited to snow, ice, and repeated wet-dry cycles
• Compact housing that clears handlebar and console trim on the listed models
• Simple plug-in style installation with no rewiring of the sled's harness

Fits These Machines

• for Polaris Rush 600 LX 2011

On-The-Job Use

• Replacing a tether switch that no longer kills the engine when the lanyard pulls out
• Restoring shutdown safety on trail and mountain rides
• Routine maintenance on older Polaris Rush snowmobiles
• Keeping a spare tether switch on hand for race weekends and deep-powder days

Specs At A Glance

Good To Know

Q: How do I know the tether switch is wired correctly? A: With the lanyard installed the engine should run normally, and pulling the cap free should kill spark immediately; if it does the opposite, the leads are reversed. Confirm your sled's connector style before ordering.

Q: Will this cap accept my existing lanyard? A: The cap is made to work with a standard pull-style lanyard, but clip and post dimensions can vary between production runs, so compare it against your original cap before install.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.