Tether Switch and Cap for Polaris Switchback 600 Adventure 2012-2019
Tether Switch and Cap for Polaris Switchback 600 Adventure 2012-2019
Couldn't load pickup availability
Tether Switch and Cap for Polaris Switchback 600 Adventure
This tether switch and cap assembly for Polaris Switchback 600 Adventure provides a safety kill connection so the engine cuts out if the rider separates from the machine.
Overview
This tether switch and cap is a replacement safety component built for the Polaris Switchback 600 Adventure snowmobile. The tether switch and cap keeps the engine kill circuit closed while the rider is attached and breaks the connection when the cord is pulled free. Riders replacing a worn or missing tether switch and cap will find this a practical match for the Switchback 600 Adventure.
Built For Performance
- Complete switch and cap assembly for a direct tether connection
- Designed to break the ignition circuit when the cord is pulled
- Housing sized to fit the Switchback 600 Adventure mounting point
- Cap retains the tether cord securely during aggressive riding
- Replacement for a worn, cracked, or non-functioning original unit
Fits These Machines
- for Polaris Switchback 600 Adventure 2012
- for Polaris Switchback 600 Adventure 2013
- for Polaris Switchback 600 Adventure 2014
- for Polaris Switchback 600 Adventure 2015
- for Polaris Switchback 600 Adventure 2016
- for Polaris Switchback 600 Adventure 2017
- for Polaris Switchback 600 Adventure 2018
- for Polaris Switchback 600 Adventure 2019
On-The-Job Use
- Trail riding where rider separation should kill the engine
- Mountain and deep snow riding with frequent dismounts
- Replacing a tether that no longer holds the cord
- Seasonal maintenance before the snow season begins
Specs At A Glance
| Type | Tether switch and cap |
| Function | Safety kill connection |
| Application | Snowmobile |
Good To Know
Q: How does a tether switch work? A: The switch completes the kill circuit only while the cap and cord are attached to the rider, so pulling free shuts the engine down.
Q: Can I install this myself? A: Yes, it mounts at the factory tether location and connects to the existing wiring, so basic hand tools are enough for most riders.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
