Tether Switch and Cap for Polaris Switchback 800 HO XCR 2020

Tether Switch and Cap for Polaris Switchback 800 HO XCR

This tether switch and cap is a safety cut-off assembly that links to the ignition so the engine shuts down if the rider leaves the machine, and it is built to fit the 2020 Polaris Switchback 800 HO XCR.

Overview

This tether switch and cap provides Polaris Switchback 800 HO XCR riders with a reliable engine kill connection. The tether switch and cap attaches to the rider and breaks the ignition circuit when pulled free, and it suits owners replacing a damaged or missing safety switch on their sled.

Built For Performance

• Safety cut-off design stops the engine when the tether is pulled from the switch
• Complete switch and cap assembly for direct replacement of the original unit
• Weather-resistant construction suited to cold, snow, and moisture exposure
• Plug-in wiring connection that matches the factory harness layout
• Compact body that mounts in the stock tether switch location

Fits These Machines

• for Polaris Switchback 800 HO XCR 2020

On-The-Job Use

• Trail riding where a working safety tether is required
• Performance riding where riders separate from the sled
• Routine replacement of a failed or intermittent kill switch
• Pre-season service and safety inspections

Specs At A Glance

Good To Know

Q: How does a tether switch work? A: The cap clips to the rider and stays seated on the switch while riding; if the rider falls, the tether pulls the cap free and the ignition circuit opens, stopping the engine.

Q: Do I need to change any wiring to install it? A: It is designed to connect at the stock tether switch wiring point, so installation is a direct replacement rather than a rewire.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.