Tether Switch and Cap for Polaris Switchback 800 Pro-R 2012-2014

Tether Switch and Cap for Polaris Switchback 800 Pro-R

This tether switch and cap is a safety cut-off assembly that connects to the ignition circuit so the engine stops if the rider separates from the machine, and it is built to fit the Polaris Switchback 800 Pro-R model years 2012 through 2014.

Overview

This tether switch and cap gives Polaris Switchback 800 Pro-R riders a dependable engine kill connection. The tether switch and cap clips to the rider and cuts ignition when pulled free, and it is intended for owners replacing a worn or missing safety switch on their sled.

Built For Performance

• Safety cut-off design stops the engine when the tether is pulled from the switch
• Complete switch and cap assembly for direct replacement of the original unit
• Weather-resistant construction suited to cold, snow, and moisture exposure
• Plug-in wiring connection that matches the factory harness layout
• Compact body that mounts in the stock tether switch location

Fits These Machines

• for Polaris Switchback 800 Pro-R 2012
• for Polaris Switchback 800 Pro-R 2013
• for Polaris Switchback 800 Pro-R 2014

On-The-Job Use

• Trail riding where a working safety tether is required
• Mountain and deep snow riding where riders separate from the sled
• Routine replacement of a failed or intermittent kill switch
• Pre-season service and safety inspections

Specs At A Glance

Good To Know

Q: How does a tether switch work? A: The cap clips to the rider and stays seated on the switch while riding; if the rider falls, the tether pulls the cap free and the ignition circuit opens, stopping the engine.

Q: Do I need to change any wiring to install it? A: It is designed to connect at the stock tether switch wiring point, so installation is a direct replacement rather than a rewire.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.