Tether Switch and Cap for Polaris Switchback Assault 600 2014-2021

Tether Switch and Cap for Polaris Switchback Assault 600

This tether switch and cap is a safety shutoff component that links to the ignition circuit so the engine stops when the tether cord pulls free of the cap, and it is designed for the Polaris Switchback Assault 600 produced from 2014 through 2021.

Overview

This tether switch and cap is a replacement safety shutoff for the Polaris Switchback Assault 600 snowmobile. The tether switch and cap holds the kill circuit closed while the corded cap is seated, then breaks it the moment the rider separates from the sled. It suits riders who want a dependable replacement tether switch and cap for trail, mountain, or backcountry use.

Built For Performance

• Made as a replacement tether switch and cap for the Polaris Switchback Assault 600
• Momentary kill action breaks the ignition circuit as soon as the tether pulls free
• Coiled tether cord with clip for attachment to a jacket, belt, or wrist strap
• Weather-resistant construction for snow, ice, and sub-freezing temperatures
• Two-wire design that matches the factory kill switch circuit

Fits These Machines

• for Polaris Switchback Assault 600 (2014-2021)

On-The-Job Use

• Trail riding where an unplanned rider separation must kill the engine quickly
• Mountain riding where a runaway sled can travel a long way on a slope
• Backcountry and powder days in cold, wet conditions
• Replacing a worn or intermittent tether switch on a used Switchback Assault 600

Specs At A Glance

Good To Know

Q: Does this tether switch and cap work on every Switchback Assault 600 from 2014 to 2021? A: The tether switch and cap is built for that model range, but wiring plugs can differ between model years. Check the connector on your sled before ordering.

Q: Can the engine run with the tether removed? A: A properly wired tether switch keeps the kill circuit closed only when the cap is seated, so the engine should not run without it. Verify the wire orientation during installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.