Throttle Cable 7080867 for Polaris RMK 600 2002-2003
Throttle Cable 7080867 for Polaris RMK 600 2002-2003
Couldn't load pickup availability
Throttle Cable for Polaris RMK 600
This throttle cable is a replacement for the Polaris RMK 600 snowmobile, connecting the thumb lever to the carburetor or throttle body so engine speed responds cleanly to rider input.
Overview
This throttle cable for Polaris RMK 600 models restores crisp, predictable throttle response on the trail or in deep snow. It is built as a direct-fit replacement for the stock cable, with the correct housing length and end fittings. Riders replacing a frayed or sticky cable will find it a straightforward swap.
Built For Performance
- Correct overall length for the RMK 600 chassis cable routing
- Fitted end terminals matched to the throttle lever and carburetor connections
- Flexible outer housing resists kinks through tight bends
- Low-friction inner wire for smooth lever travel
- Protective jacket against moisture and abrasion in snow conditions
Fits These Machines
- for Polaris RMK 600, 2002
- for Polaris RMK 600, 2003
On-The-Job Use
- Replacing a frayed or binding throttle cable during preseason service
- Restoring smooth thumb lever operation on a mountain sled
- Trailside repair when a cable snaps mid-ride
- Routine maintenance on 2002 and 2003 RMK 600 machines
Specs At A Glance
| Part Number(s) | 7080867 |
| Part Type | Throttle cable |
| Application | for Polaris RMK 600 |
| Model Years | 2002-2003 |
Good To Know
Q: Does the cable come pre-lubed? A: Light lubrication of the inner wire before installation helps keep lever action smooth and extends cable life. Q: Will I need to adjust the cable after fitting? A: Yes, set free play at the lever to the factory specification so the throttle closes fully and opens without binding.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
