Throttle Cable for Honda ATC250R ATC 250R 1981-1982

Throttle Cable for Honda ATC250R

This throttle cable for Honda ATC 250R three-wheelers links the twist grip to the carburetor so engine speed responds directly to rider input, and it is a new replacement unit for the 1981 through 1982 models.

Overview

This throttle cable for Honda is a new replacement built for ATC250R models from 1981 and 1982. It carries throttle input from the grip to the carburetor so the engine responds smoothly through the rev range. It is aimed at owners keeping an ATC 250R running or bringing one back to rideable condition.

Built For Performance

• New cable, not a take-off or refurbished part
• Fits ATC250R models from 1981 and 1982
• Inner cable sized for smooth movement inside the sheath
• Correct end fittings for the throttle grip and carburetor
• Built to handle the heat and vibration of two-stroke use

Fits These Machines

• for Honda ATC250R 1981
• for Honda ATC250R 1982

On-The-Job Use

• Trail and dune riding where throttle feel matters
• Replacing a cable that has stretched or seized
• Refreshing a vintage ATC 250R during a rebuild
• Scheduled maintenance on a three-wheeler still in service

Specs At A Glance

Good To Know

Q: Will this cable work on later ATC250R models? A: This cable is listed for the 1981 and 1982 ATC 250R, and later model years may use a different cable. Confirm your model year and cable routing before ordering.

Q: What should I check after fitting a new throttle cable? A: Verify the carburetor slide closes fully when the grip is released and set the correct free play. Also check that the cable is routed without sharp bends.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.