Throttle Cable for Honda CR125R CR 125R 1984

Throttle Cable for Honda CR125R

This new throttle cable is a replacement for the Honda CR125R, running from the twist grip to the carburetor so the slide opens smoothly and returns fully after every twist.

Overview

This throttle cable is a fresh replacement for the Honda CR125R, built to the length and end fittings the 1984 model needs for correct routing to the carburetor. On a two-stroke motocross bike, cable condition directly affects throttle feel, and a worn or frayed unit can stick open, so fitting a new cable is cheap insurance. It suits riders restoring or maintaining an 1984 CR125R who want dependable response at the track or on the trail.

Built For Performance

• Direct replacement for the stock throttle cable on the Honda CR125R
• Pre-lubricated inner cable for smooth slide movement
• Correct length and end fittings for the 1984 model
• Tough outer sheath resists rubbing from bar turns and fork travel
• Pre-formed elbow and nipples match the original routing path

Fits These Machines

• for Honda CR125R (1984)

On-The-Job Use

• Replacing a stretched or frayed cable during a top-end rebuild
• Fixing slow or sticky throttle return before a race weekend
• Refreshing a bike that sat stored with a seized cable

Specs At A Glance

Good To Know

Q: How do I know if my throttle cable needs replacing? A: Sticky, slow-returning, or snagging throttle action on a Honda CR125R usually points to a stretched or frayed cable. Check the inner wire at both ends for broken strands and replace the cable if the sheath is cracked or the slide does not snap back.

Q: Does this cable need any adjusting after install? A: Yes, there is normally a barrel adjuster at the lever or carburetor cap that sets free play. Leave a small amount of slack so the throttle returns fully and the slide sits closed at idle.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.