Throttle Cable for Ski-Doo TNT 440 1977 1978
Throttle Cable for Ski-Doo TNT 440 1977 1978
Couldn't load pickup availability
Throttle Cable for Ski-Doo TNT 440
This throttle cable is a direct-fit replacement for the Ski-Doo TNT 440 snowmobile, restoring smooth, responsive throttle control from handlebar lever to carburetor.
Overview
This throttle cable is built to replace a worn or frayed cable on the Ski-Doo TNT 440, delivering reliable throttle response when you need it. A fresh throttle cable for the Ski-Doo TNT 440 removes slop and binding so the lever returns cleanly and acceleration stays predictable. It suits riders maintaining a vintage sled for trail and field use.
Built For Performance
- Inner cable designed for low-friction movement through the housing
- Flexible outer housing resists kinks and routing wear
- Pre-fitted end fittings for straightforward installation
- Construction suited to cold-weather snowmobile use
- Direct replacement for the original cable on the TNT 440
Fits These Machines
- for Ski-Doo TNT 440, 1977-1978
On-The-Job Use
- Trail riding where consistent throttle response matters
- Restoring a vintage sled for seasonal use
- Routine replacement of a stretched or frayed cable
- Field and lake riding in cold conditions
Specs At A Glance
| Product Type | Throttle Cable |
| Machine | for Ski-Doo TNT 440 |
| Model Years | 1977-1978 |
Good To Know
Q: How do I know this cable fits my sled? A: It is listed for the Ski-Doo TNT 440, 1977-1978. Confirm your model year and cable routing before ordering.
Q: Should I lubricate the cable before install? A: Light cable lubrication can help smooth operation and extend service life. Route the cable without sharp bends to avoid binding.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
