Throttle Cable for Yamaha Banshee 350 1987-2006

Throttle Cable for Yamaha Banshee 350

This throttle cable is a replacement unit for the Yamaha Banshee 350, connecting the thumb throttle to the carburetor so engine response stays crisp and controlled.

Overview

This throttle cable is made to replace a stretched, sticky, or broken cable on the Yamaha Banshee 350. It delivers smooth throttle actuation so the engine responds cleanly from idle to full pull. Riders needing a fresh throttle cable for the Banshee 350 get a direct-fit part that installs with basic tools.

Built For Performance

• Inner cable moves freely through the outer sheath for smooth throttle action
• Outer housing resists heat, moisture, and abrasion in the engine bay
• End fittings match the factory throttle and carburetor connections
• Reinforced terminations resist fraying from repeated throttle use
• Pre-lubricated inner wire reduces friction for a lighter throttle pull

Fits These Machines

• for Yamaha Banshee 350 1987-2006

On-The-Job Use

• Dune and trail riding where instant throttle response matters
• Replacing a cable that has stretched or seized over time
• Routine maintenance on a vintage Banshee 350
• Restoring a machine that has sat unused for a season

Specs At A Glance

Good To Know

Q: Will this cable fit every Banshee 350 year from 1987 to 2006? A: It is listed for that full range, but confirming your exact model year and carburetor setup before ordering is recommended.

Q: Does the cable come pre-lubricated? A: Yes, the inner wire is pre-lubricated, though adding cable lube during installation helps maintain smooth operation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.