Throttle Lever w Thumb Warmer for Ski-Doo Grand Touring LE 600 HO E-Tec 2015-201

Throttle Lever with Thumb Warmer for Ski-Doo

This throttle lever with integrated thumb warmer is a direct-fit replacement control for Ski-Doo Grand Touring LE 600 HO E-Tec snowmobiles, letting you operate the throttle while keeping your thumb warm on cold rides.

Overview

This throttle lever with thumb warmer is built to replace the worn or damaged throttle control on your Ski-Doo Grand Touring LE 600 HO E-Tec. The integrated thumb warmer element delivers consistent heat to your thumb so you can maintain precise throttle control in freezing conditions. It is intended for riders who want a dependable, factory-style replacement without hunting down discontinued parts.

Built For Performance

• Integrated thumb warmer element for reliable heat output in cold weather
• Direct-fit geometry matched to the 600 HO E-Tec throttle body assembly
• Durable construction engineered for repeated squeeze cycles on the trail
• Plug-in style wiring connection for the warmer circuit where applicable
• Replaces a cracked, sticky, or non-heating original throttle lever

Fits These Machines

• for Ski-Doo Grand Touring LE 600 HO E-Tec 2015
• for Ski-Doo Grand Touring LE 600 HO E-Tec 2016
• for Ski-Doo Grand Touring LE 600 HO E-Tec 2017

On-The-Job Use

• Trail riding in sub-freezing temperatures where thumb comfort matters
• Replacing a lever that no longer heats or that sticks during throttle application
• Routine handlebar control maintenance on high-mileage touring sleds
• Restoring factory-style throttle feel after an accident or rollover

Specs At A Glance

Good To Know

Q: Will this lever work with my existing thumb warmer wiring? A: The lever is built to connect to the factory warmer circuit on the listed Grand Touring LE 600 HO E-Tec models. Confirm your sled's connector style matches before ordering.

Q: Do I need any special tools to install it? A: Basic hand tools and a bit of mechanical skill are typically enough for this throttle lever swap. Disconnect the battery or warmer circuit before starting the job.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.