Throttle Position Sensor for Ski-Doo Grand Touring/LE 600 E-Tec 2011-2018
Throttle Position Sensor for Ski-Doo Grand Touring/LE 600 E-Tec 2011-2018
Couldn't load pickup availability
Throttle Position Sensor for Ski-Doo
This throttle position sensor is a replacement electrical component that reports throttle plate angle to the engine management system on the listed Ski-Doo Grand Touring and Grand Touring LE 600 E-Tec models.
Overview
This throttle position sensor is a direct-fit replacement for the Ski-Doo Grand Touring and Grand Touring LE 600 E-Tec, feeding the ECM the throttle angle signal needed for correct fueling and ignition timing. The throttle position sensor installs in place of the original unit on 2011 through 2018 models and restores the signal path the engine depends on for clean throttle response. It suits riders and independent shops diagnosing a faulty or erratic throttle signal on a touring E-Tec sled.
Built For Performance
- Plug-in electrical connection matching the stock harness
- Sealed housing built to resist moisture and vibration on the trail
- Contactless sensing element with no wearing wiper track
- Direct mounting footprint for the 600 E-Tec throttle body
- Signal output compatible with the factory engine management system
Fits These Machines
- for Ski-Doo Grand Touring 600 E-Tec, 2011-2018
- for Ski-Doo Grand Touring LE 600 E-Tec, 2011-2018
On-The-Job Use
- Replacing a failed sensor that causes rough running or a check engine light
- Routine electrical service on 2011-2018 touring E-Tec sleds
- Restoring consistent throttle response for long-distance touring
- Shop or home garage diagnostics and repair work
Specs At A Glance
| Type | Throttle Position Sensor |
| Fitment | for Ski-Doo Grand Touring and Grand Touring LE 600 E-Tec |
| Model Years | 2011-2018 |
Good To Know
Q: Does this sensor need calibration after installation? A: Most applications set throttle position automatically after a short idle relearn. Verify against your model's service procedure if the ECM stores a throttle code.
Q: Can a bad throttle position sensor cause a check engine light? A: Yes, an out-of-range throttle signal commonly triggers a fault code and limp behavior. Replacing the sensor restores the correct signal to the ECM.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
