Throttle Position Sensor for Ski-Doo Renegade Backcountry X 800 E-Tec 2011-2017
Throttle Position Sensor for Ski-Doo Renegade Backcountry X 800 E-Tec 2011-2017
Couldn't load pickup availability
Throttle Position Sensor for Ski-Doo Renegade Backcountry/X 800 E-Tec
This throttle position sensor for Ski-Doo snowmobiles monitors throttle plate angle and sends that signal to the engine control module to keep fuel delivery and ignition timing on point.
Overview
This throttle position sensor for Ski-Doo is a replacement electronic component that reports throttle opening to the ECU. It helps maintain crisp throttle response and stable fuel mapping on the Renegade Backcountry and X 800 E-Tec. A practical fix for riders chasing down idle or hesitation issues.
Built For Performance
- Direct-fit replacement for the original sensor
- Sealed body resists moisture, snow, and vibration
- Stable voltage output across the throttle range
- Connector matches the factory harness
- Built to hold calibration through temperature swings
Fits These Machines
- for Ski-Doo Renegade Backcountry 800 E-Tec, 2011-2017
- for Ski-Doo Renegade X 800 E-Tec, 2011-2017
On-The-Job Use
- Replacing a sensor that causes rough idle or hesitation
- Deep snow and backcountry riding where throttle response matters
- Diagnostic and electrical repair work on the intake system
- Pre-season maintenance before the first ride
Specs At A Glance
| Type | Throttle Position Sensor |
| Connection | Factory-style plug |
| Fitment Years | 2011-2017 |
Good To Know
Q: What symptoms point to a bad throttle position sensor? A: Rough idle, hesitation, and throttle circuit fault codes are the usual signs. A voltage sweep test confirms whether the sensor is failing.
Q: Will this sensor need calibration after installation? A: Most machines relearn throttle position automatically after install and a key cycle. Verify the procedure in your service manual.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
