Tie Rod End Fit for Kubota L3240DT/GST L3240DT-3 L3240GST-3 L3130DT/GST/HST

Tie Rod End Fit for Kubota

This tie rod end fit for Kubota is a steering linkage component that connects the steering arm to the wheel spindle for precise control on multiple L-series tractor models. It is designed as a direct replacement for worn parts on the L3240 and L3130 series. This tie rod end fit for Kubota ensures stable steering and reduced downtime.

Overview

This tie rod end fit for Kubota serves as a critical steering joint, converting rotational input from the steering box into linear motion to turn the wheels accurately. It is intended for tractors in the Kubota L3240 and L3130 families, including gear, glide shift, and hydrostatic transmission variants. Replacing a faulty tie rod end fit for Kubota restores original steering response and prevents premature tire wear.

Built For Performance

• Manufactured from high-strength alloy steel to withstand repeated stress
• Threaded ends allow for precise toe-in adjustment during installation
• Sealed socket keeps out dirt and moisture to prolong joint life
• Includes a grease fitting for easy lubrication and smooth operation
• Designed to match OEM thread pitch and taper for a secure fit

Fits These Machines

• for Kubota L3240DT
• for Kubota L3240GST
• for Kubota L3240DT-3
• for Kubota L3240GST-3
• for Kubota L3130DT
• for Kubota L3130GST
• for Kubota L3130HST

On-The-Job Use

• Commonly used during front-end steering repairs on compact utility tractors
• Supports tasks such as loader work, grading, and tilling that demand accurate steering
• Works for mowing and property maintenance where tight maneuvering is required

Specs At A Glance

Good To Know

Q: Will this tie rod end fit both left and right sides of the tractor? A: Tie rod ends are often side-specific, so check the orientation of your existing part. If the original is straight and not angled, it may fit either side, but verifying the thread direction is essential.

Q: How should I install this tie rod end? A: Clean the mounting surfaces, apply anti-seize to the threads, and torque the nut to the manufacturer's specification. After installation, perform a front-end alignment to ensure correct toe setting.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.