Top End Gasket Set for Kawasaki STX DI 1100 2000-2003

Top End Gasket Set for Kawasaki STX DI 1100

This top end gasket set provides the seals and gaskets needed to reassemble the upper cylinder section on a Kawasaki STX DI 1100 personal watercraft engine after a rebuild or repair.

Overview

This top end gasket set for Kawasaki is built to seal the cylinder head, cylinder base, and exhaust connections on the STX DI 1100 engine. The set gives riders and mechanics the gaskets required for a top end rebuild without hunting down individual seals. It fits 2000 through 2003 model years.

Built For Performance

• Includes gaskets for cylinder head and cylinder base sealing
• Cut to match the STX DI 1100 engine deck and head surfaces
• Designed to handle the heat and pressure of two-stroke marine operation
• Provides a complete top end sealing solution in one set
• Compatible with the 2000-2003 STX DI 1100 model run

Fits These Machines

• for Kawasaki STX DI 1100 2000
• for Kawasaki STX DI 1100 2001
• for Kawasaki STX DI 1100 2002
• for Kawasaki STX DI 1100 2003

On-The-Job Use

• Top end rebuilds after piston or ring replacement
• Cylinder head removal and reinstallation
• Routine engine refresh on aging STX DI 1100 watercraft
• Seasonal maintenance before returning to the water

Specs At A Glance

Good To Know

Q: Does this set include all gaskets needed for a full top end rebuild? A: It covers the standard top end sealing points such as head and base gaskets, though specific included components can vary by set. Compare the contents against your service manual before starting.

Q: Can I reuse these gaskets if I disassemble the engine again? A: Gaskets are designed for single-use sealing and should be replaced any time the joint is opened. Reusing a compressed gasket risks leaks and compression loss.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.