Top End Gasket Set for Tiger Shark Montego DX 640 1994

Top End Gasket Set for Tiger Shark Montego DX 640

This top end gasket set seals the cylinder head, base, and exhaust joints on a 1994 Tiger Shark Montego DX 640, restoring compression and stopping leaks during a rebuild.

Overview

This top end gasket set is a complete sealing kit for the upper half of a 1994 Tiger Shark Montego DX 640 engine. It covers the gaskets needed when removing and refitting the cylinder head, base, and exhaust so the engine holds compression and runs clean. Designed for rebuilders and watercraft owners doing their own top end service on a Tiger Shark Montego DX 640.

Built For Performance

• Cut to original equipment profiles for correct port and bolt hole alignment
• Heat resistant material that holds its seal under repeated thermal cycling
• Covers head, base, and exhaust joints for a full top end reseal
• Compressible construction helps compensate for minor surface imperfections
• Sold as a complete set so the job can be finished in one pass

On-The-Job Use

• Top end rebuilds after a piston or ring replacement
• Cylinder base and head resealing after a tear down
• Fixing compression loss and coolant or exhaust leaks at the deck
• Routine refresh on high hour personal watercraft engines

Specs At A Glance

Good To Know

Q: Does this set cover the whole engine? A: No, it is a top end set covering the cylinder head, base, and related upper joints only. Bottom end seals and bearings are not included.

Q: Can I reuse the old gaskets if the engine comes apart again? A: Gaskets are single use and should be replaced any time the joint is opened. Order a fresh set for each rebuild.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.