Top End Gasket Set for Yamaha Enticer 250 1977-1981

Top End Gasket Set for Yamaha Enticer 250

This top end gasket set provides the seals and gaskets needed to reseal the cylinder and head on a Yamaha Enticer 250 engine during a rebuild or top end service.

Overview

This top end gasket set is built for the Yamaha Enticer 250 produced between 1977 and 1981. It supplies the gaskets required to seal the cylinder base, head, and related top end surfaces after a rebuild, helping the engine hold compression and run cleanly. Anyone refreshing a vintage Enticer 250 will find this top end gasket set an essential piece of the rebuild.

Built For Performance

• Includes the gaskets needed to reseal the top end
• Cut to match the cylinder and head sealing surfaces of the Enticer 250
• Heat-resistant material suited to two-stroke operating temperatures
• Fresh gaskets help restore proper compression and sealing
• Intended for rebuild and repair use

Fits These Machines

• for Yamaha Enticer 250, 1977-1981

On-The-Job Use

• Top end rebuilds after a piston or ring replacement
• Resealing a cylinder that has developed a base or head leak
• Restoring a vintage Enticer 250 that has lost compression
• Routine maintenance on a high-hour two-stroke engine

Specs At A Glance

Good To Know

Q: What is included in a top end gasket set? A: A top end gasket set typically covers the cylinder base gasket, head gasket, and related sealing pieces for the upper portion of the engine. Exact contents depend on the set, so check what is supplied before starting your Enticer 250 rebuild.

Q: Can I reuse old gaskets during a rebuild? A: No, gaskets are meant to be replaced each time the top end is opened, since used gaskets will not seal reliably. Always install fresh gaskets to avoid compression leaks on your Enticer 250.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.