Track Drive Shaft Bearing & Seal Kit for Polaris Indy Trail 488 1994-1997

Track Drive Shaft Bearing & Seal Kit for Polaris Indy Trail 488

This track drive shaft bearing and seal kit provides the replacement components needed to restore smooth rotation and proper sealing on the drive shaft of a Polaris Indy Trail 488 snowmobile.

Overview

The track drive shaft bearing and seal kit is built to replace worn or failed bearings and seals on the drive shaft of a Polaris Indy Trail 488. This kit keeps the drive shaft turning freely while sealing out snow, water, and debris that cause premature wear. It is a practical solution for riders performing routine maintenance or rebuilding a drive system on 1994 through 1997 models.

Built For Performance

• Replacement bearing sized for the track drive shaft application
• Matching seal to keep moisture and contaminants out of the bearing
• Designed to restore smooth drive shaft rotation
• Construction suited to cold-weather snowmobile operation
• Direct-fit components for the listed Polaris Indy Trail 488 application

Fits These Machines

• for Polaris Indy Trail 488 1994
• for Polaris Indy Trail 488 1995
• for Polaris Indy Trail 488 1996
• for Polaris Indy Trail 488 1997

On-The-Job Use

• Drive shaft bearing replacement during seasonal maintenance
• Drivetrain rebuilds on Indy Trail 488 snowmobiles
• Repairing noisy or rough-turning drive shafts
• Restoring sealed protection after bearing failure

Specs At A Glance

Good To Know

Q: What does this kit include? A: It includes the drive shaft bearing along with the matching seal for the listed Polaris Indy Trail 488 application.

Q: How do I know if my bearing needs replacing? A: Rough rotation, noise, or visible seal damage on the drive shaft are common signs that the bearing and seal should be replaced.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.