Track Drive Shaft Chain Case Bearing Seal for Ski-Doo Summit 1000 2005-2007

Track Drive Shaft & Chain Case Bearing & Seal for Ski-Doo Summit 1000

This track drive shaft and chain case bearing and seal set fits Ski-Doo Summit 1000 models 2005-2007, keeping the driveline turning smoothly.

Overview

This track drive shaft and chain case bearing and seal set for Ski-Doo Summit 1000 models 2005-2007 supports the driveline inside the chain case. The bearing and seal keep the shaft turning freely while holding oil in and dirt out. It is built for riders and mechanics servicing a Summit 1000 snowmobile.

Built For Performance

• Bearings sized to carry the drive shaft load in the chain case
• Seals designed to retain chain case oil and block contaminants
• Components matched to Ski-Doo Summit 1000 driveline geometry
• Direct replacement for worn bearings and leaking seals
• Heat and load rated for sustained trail use

Fits These Machines

• for Ski-Doo Summit 1000 2005
• for Ski-Doo Summit 1000 2006
• for Ski-Doo Summit 1000 2007

On-The-Job Use

• Chain case service on Ski-Doo Summit 1000 snowmobiles
• Replacing a noisy or seized drive shaft bearing
• Fixing oil leaks at the chain case seal
• Seasonal driveline maintenance

Specs At A Glance

Good To Know

Q: How do I know the chain case bearing is failing? A: Grinding or rumbling from the chain case, metal in the oil, or a leaking seal often signal a bearing that has worn out and needs replacement.

Q: What should I check when replacing the seal? A: Inspect the shaft surface for grooves and confirm the bearing seats properly, since a worn shaft can make a new seal leak again.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.