Track Drive Shaft Chain Case Bearing Seal Kit for Ski-Doo Skandic Tundra 550

Track Drive Shaft/Chain Case Bearing & Seal Kit for Ski-Doo

This track drive shaft and chain case bearing and seal kit provides the bearings and seals required to service the driveline of a Ski-Doo Skandic or Tundra 550 snowmobile.

Overview

This track drive shaft and chain case bearing and seal kit is made for the Ski-Doo Skandic and Tundra 550 and supplies the components that keep the drive shaft and chain case operating correctly. The kit bundles bearings and seals so the driveline can be serviced in one go on the Skandic or Tundra 550. It is intended for riders handling maintenance or rebuilding a worn chain case assembly.

Built For Performance

• Bearing and seal set matched to the Ski-Doo Skandic and Tundra 550 driveline
• Seals retain lubricant and block contaminants from the chain case
• Bearings carry the load of the track drive shaft
• Complete kit format removes the need to source parts individually
• Designed as a replacement for worn driveline components

Fits These Machines

• for Ski-Doo Skandic 550
• for Ski-Doo Tundra 550

On-The-Job Use

• Chain case service on the Skandic and Tundra 550
• Track drive shaft bearing replacement
• Routine driveline maintenance
• Repairs after seal leaks or bearing wear

Specs At A Glance

Good To Know

Q: What does this kit cover? A: It includes the bearings and seals for the track drive shaft and chain case on the listed Ski-Doo Skandic and Tundra 550 models. Check the quantities against your machine before ordering.

Q: Is this suitable for a full chain case rebuild? A: The kit supplies the bearings and seals for that job, though additional driveline parts may be needed depending on condition. Inspect all components during disassembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.