Traction Mat Self Adhesive for Kawasaki Ultra 250X 1500 2007-2008

Self Adhesive Traction Mat for Kawasaki Ultra 250X 1500

This self adhesive traction mat is a direct-fit replacement deck pad set made for the Kawasaki Ultra 250X 1500, giving riders renewed grip on the footwells and rear deck of their personal watercraft.

Overview

The self adhesive traction mat for Kawasaki Ultra 250X 1500 restores the non-slip surface riders rely on when boarding, cornering, and reboarding after a swim. This traction mat set is built for PWC owners replacing worn, peeled, or sun-baked factory padding with fresh peel-and-stick material. Each piece is cut to suit the 2007 to 2008 Ultra 250X 1500 platform.

Built For Performance

• Peel-and-stick adhesive backing bonds to clean, dry fiberglass and gelcoat surfaces
• Textured raised pattern sheds water and improves boot and glove grip
• Closed-cell foam construction resists water absorption and UV breakdown
• Pre-shaped pieces follow the contours of the Ultra 250X 1500 footwells and rear deck
• Trimmable edges allow fine fitting around bond rails and tow hooks
• Cushioned surface softens impacts during aggressive riding

Fits These Machines

• for Kawasaki Ultra 250X 1500, 2007
• for Kawasaki Ultra 250X 1500, 2008

On-The-Job Use

• Replacing cracked or lifting factory deck padding on a used PWC
• Improving footing during tight buoy turns and slalom runs
• Refreshing the rear boarding platform for easier reboarding from the water
• Routine cosmetic and safety upkeep on a seasonally used jet ski

Specs At A Glance

Good To Know

Q: How should the surface be prepared before installing this traction mat? A: Clean the deck with alcohol or a mild degreaser and let it dry fully so the adhesive bonds properly. Apply the mat in warm conditions and press firmly across the entire surface.

Q: Can this traction mat be trimmed if it overhangs the deck edges? A: Yes, the foam can be cut with a sharp blade or scissors to fine-tune the fit around hardware. Trim small amounts at a time and test-fit before pressing into place.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.