TRX250R Ball Joint Separator Tool for Honda TRX 250R 1986-1989

Ball Joint Separator Tool for Honda TRX 250R

This ball joint separator tool is made for Honda TRX 250R machines from 1986 through 1989, giving you a direct way to pop tapered ball joints free during front end service.

Overview

This ball joint separator tool is built to service the front suspension on Honda TRX 250R ATVs from the 1986 to 1989 model years. The TRX250R ball joint separator tool lets you break the taper between the ball joint stud and the knuckle without hammering on expensive parts. It is aimed at riders, racers, and shops keeping a TRX 250R running.

Built For Performance

• Fits the Honda TRX 250R front suspension layout from 1986 through 1989
• Heavy duty steel body handles high separating force
• Tapered fork wedges cleanly under the ball joint stud
• Accepts a standard wrench or impact driver for turning
• Even load spread helps protect the ball joint boot and knuckle

Fits These Machines

• for Honda TRX 250R 1986
• for Honda TRX 250R 1987
• for Honda TRX 250R 1988
• for Honda TRX 250R 1989

On-The-Job Use

• Front end rebuilds and ball joint swaps on the TRX 250R
• Race prep and suspension refresh work
• ATV shops servicing older Honda two stroke quads
• Garage based restoration of a TRX 250R

Specs At A Glance

Good To Know

Q: Can this separator be used on the trail? A: It is a hand tool meant for bench or garage use, though it travels easily in a tool kit. A solid flat surface makes the job safer and faster.

Q: What should I check after separating the joint? A: Inspect the ball joint stud and the knuckle bore for wear or scoring before reassembly. Replace any damaged parts and torque the nut to the figure listed for your TRX 250R.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.