Turbo Charger FIT Honda CRV Civic 1.5/2.0L L15B7 2SV 2HX 49373-07012 49373-07011
Turbo Charger FIT Honda CRV Civic 1.5/2.0L L15B7 2SV 2HX 49373-07012 49373-07011
Couldn't load pickup availability
Turbo Charger for Honda CR-V and Civic 1.5L and 2.0L
This turbo charger for Honda CR-V and Civic 1.5L and 2.0L replaces the factory unit and cross-references OEM numbers 49373-07012 and 49373-07011, restoring the boost response the L15B7, 2SV, and 2HX engines are tuned for.
Overview
This turbo charger is a direct-fit replacement for the factory unit on Honda CR-V and Civic models running 1.5L and 2.0L engines, cross-referenced to OEM 49373-07012 and 49373-07011. It bolts in where the original sat and brings back the spool, boost, and drivability that a worn or failed turbo takes away. It suits daily drivers and shop repairs where a dependable replacement is what the job calls for.
Built For Performance
- Cross-references OEM part numbers 49373-07012 and 49373-07011
- Direct replacement footprint for the CR-V and Civic turbo mounting
- Built to handle the boost and heat cycling of the L15B7, 2SV, and 2HX engines
- Sealed bearing housing designed to keep oil where it belongs under load
- Balanced rotating assembly for smooth spool and stable boost
Fits These Machines
- for Honda CR-V 1.5L
- for Honda CR-V 2.0L
- for Honda Civic 1.5L
- for Honda Civic 2.0L
On-The-Job Use
- Replacing a failed or oil-burning factory turbo on a daily-driven CR-V
- Restoring boost on a Civic that has gone into limp or lost top-end pull
- Shop repairs where a cross-referenced OEM-match unit is required
- Bringing a high-mileage 1.5L or 2.0L engine back to factory boost behavior
Specs At A Glance
| Part Number(s) | 49373-07012, 49373-07011 |
| Engine Codes | L15B7, 2SV, 2HX |
| Displacement | 1.5L and 2.0L |
Good To Know
Q: Is this an exact match for the OEM turbo numbers listed? A: It is cross-referenced to 49373-07012 and 49373-07011, so it is built to replace those units. Verify your turbo housing number against the listing before ordering.
Q: What should be replaced at the same time as the turbo? A: Fresh oil feed and drain lines plus a new gasket set are commonly done with turbo replacement. Confirm the install kit for your exact engine code.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
